What it is

Lens blur softens what is behind (and in front of) your subject, like a wide-open lens.

Where to find it

Open a gallery, click Edit on a photo, then open Lens blur in the panel on the right.

Steps

  1. Open the photo in the editor and click Lens blur.
  2. Move Blur amount up.
  3. Click Pick focus, then click the part of the photo that should stay sharp.
  4. Move Focus range to choose how much around that point stays sharp.
  5. Leave Keep people sharp ticked to keep people in focus, or untick it.
  6. On a computer, you can also click Draw around subject (or press D), click around your subject and click the first point (or press Enter) to close. Inside stays sharp, everything outside blurs.
  7. Or use Keep sharp brush to paint over anything that should never blur. Tick Erase (or hold Alt) to take paint away.

Good to know

  • The blur shows a moment after you stop.
  • If Blur amount is at 0, Draw around subject turns Lens blur on at 40. Move the slider to change it.
  • Draw around subject and Keep sharp brush are on a computer only.
  • Press Z to zoom in when you trace closely.
  • Use Clear path or Clear to start a path or brush again.
Was this guide helpful?

Stuck? Email [email protected] with a screenshot, or open Support from inside HeyShutter.